All Categories

Home> Blogs> Laboratory centrifuge using steps in hospital

Laboratory centrifuge using steps in hospital

2022-10-17 Hits: 17 views

Step 4: Parameter setting.

This step is to choose the appropriate speed or centrifugal force. Must choose the right conditions, too low conditions can not achieve the effect, too high conditions will cause material loss. Therefore, it is necessary to make good reference and combine relevant experience. Pay attention to the balance of centrifugal materials

Step 5: Safety issues.

Cover the centrifuge cover, this step must be sure to cover tightly, because if the cover is not good, it is easy to cause danger

Step 6: Pay attention to the details.

We should pay attention to the preservation of the final supernatant or precipitation, and remember to take the supernatant or discard the supernatant quickly, so as not to cause partial suspension over time, resulting in good experimental results

Leave a comment

Your email address will not be published. Required fields are marked *

+86-731-88137982 [email protected]